So if that's what you see - instant full speed, then slow down - you mobo headers ARE controlling your fan speeds. The normal sequence is that all fans will start up at full speed, but in a few seconds as the system gets info gathered it finds that the temperatures are low ans slows down all those fans. When fan sync in MSI Afterburner is enabled the fan speed. Just as your system reboots, observe the fans carefully and quickly. WARNINGS CEILING FAN HANDHELD CONTROL Model 99198 This product is warranted to the. 56 and choose the second item, "Save Changes and Reboot." This will save your changes and reboot. Then use Esc to get back to the main screen and click on Save and Exit at top right. Use the Esc key to back up one level and access the next header until you get them all set. Download MSI Afterburner 4.6.3 Beta 5 (16041) from Changelog AMD Navi 21 GPU architecture support New hybrid automatic software fan control mode. Aumentando la frequenza di clock e la tensione della GPU, il controllo della velocità della ventola ti consentirà di trovare il perfetto equilibrio tra prestazioni e temperatura. But for EACH SYS_FAN header that you are using for your case fans, ensure that the header is set to use DC Mode. Lo strumento MSI Afterburner Overclocking fornisce un accesso facile e preciso alle impostazioni della scheda grafica. The manual does not show details for that. I am in the habit of not merely pressing that key I hold it down until the BIOS Setup opening screen (p.40) appears. MSI Afterburner not only allows you to increase the voltage and clock frequency of your GPU, but it also allows you full control of fan cooling. It says when you start up the system, press the "Del" key. Fan Control is not an official HWiNFO feature and there are currently only very few specific machines supported: Alienware all current models should be supported, but there are limitations based on model and fan control mode (EC support disabled/enabled) DELL many models supported, but fan control limited to 3 levels only. On p.33 of your manual it says you can make this setting for EACH of the headers you are using by accessing the correct BIOS Setup screens. To control their speeds your mobo header they are plugged into MUST be configured to use the older Voltage Control Mode (aka DC Mode) and NOT the newer PWM Mode. I am pretty sure each has THREE wires from it (Red, Black and Yellow), and they end in a connector with THREE holes. Look at the wires from each of your four fans.
0 Comments
Leave a Reply. |